PCP #31523 · Syngenta Canada Inc. · Fungicide
Group 7 and Group 11 broad-spectrum fungicide containing benzovindiflupyr and azoxystrobin with preventative and systemic properties for control or suppression of important ornamental diseases including Alternaria leaf spot, downy mildew, powdery mildew, rust, anthracnose, Botrytis grey mould, and suppression of cercospora leaf spot in outdoor and greenhouse ornamentals.
Crop × pest × application rate combinations from the official label. Rates converted to per-acre. PHI is the pre-harvest interval; REI is the restricted-entry interval. Always confirm against the official label PDF before applying.
| Crop | Target | Rate | PHI | REI |
|---|---|---|---|---|
| Ornamentals | Alternaria leaf spot (Alternaria spp.) | 39 g/100L | – | 12 d |
| Ornamentals | Anthracnose (Colletotrichum spp.) | 39–50 g/100L | – | 12 d |
| Ornamentals | Botrytis grey mould (Botrytis cinerea) | 39–50 g/100L | – | 12 d |
| Ornamentals | Downy mildew (Peronospora spp.) |
| 39 g/100L |
| – |
| 12 d |
| Ornamentals | Powdery mildew (Oidium spp., Erysiphe spp., Sphaerotheca spp.) | 39–50 g/100L | – | 12 d |
| Ornamentals | Rust (Puccinia spp.) | 39–50 g/100L | – | 12 d |
| Ornamentals | Suppression of cercospora leaf spot (Cercospora spp.) | 50 g/100L | – | 12 d |
Adjuvant requirements, compatibility notes, and mixing restrictions from the official label. Always confirm against the official label PDF before mixing.
| Guidance | Adjuvant | Rate |
|---|---|---|
| Required | adjuvants approved for ornamental plants Use only adjuvants approved for ornamental plants | – |
| Recommended | HiActivate® NIS Addition of spreading/penetrating type adjuvant such as non-ionic based surfactant or blend is recommended to enhance coverage on hard-to-wet plant foliage | – |
| Recommended | non-ionic surfactant or spreading/penetrating type adjuvant A spreading/penetrating type adjuvant such as a non-ionic based surfactant or blend is recommended. Follow the adjuvant directions for use. If no directions for use are indicated use 0.125% v/v | 0.125% v/v (if no directions for use are indicated on the adjuvant label) |
| Do not mix | Silicone-containing products Silicone-containing products combined with MURAL Fungicide may cause phytotoxicity | – |
| Do not mix | high rates of silicone-based or oil containing additives or adjuvants Under certain weather conditions, particularly high temperatures, MURAL Fungicide applied with high rates of silicone-based or oil containing additives or adjuvants may cause injury | – |
| Do not mix | high rates of silicone-based or oil containing (petroleum or crop) additives or adjuvants Under certain weather conditions, particularly high temperatures, MURAL Fungicide applied in combination with high rates of silicone-based or oil containing (petroleum or crop) additives or adjuvants may cause injury. | – |
About this content. This page presents the official PRD label as published by Health Canada's Pesticides Regulatory Directorate (formerly the Pest Management Regulatory Agency), the source of record. Always read the official label and consult your provincial pesticide- application authority before use. Report an error.
